Find answers, ask questions, and connect with our <br>community around the world.

Home Forums OpenFOAM Forum WSL instructions

  • WSL instructions

    Posted by umara on October 26, 2023 at 10:40 am

    when we change input for mesh on gedit, paraview mesh doesnt change it dimension on refresh. Are there some different instruction when one is using wsl? should it be touch command again or save again

    Barış Bicer replied 5 months, 2 weeks ago 3 Members · 5 Replies
  • 5 Replies
  • MIDHUN

    Member
    October 26, 2023 at 6:21 pm

    Haie,

    You can edit the file save it, rerun BlockMesh and then create a temporary file and open in paraview.

    Regards

    Flowthermolab SupportTeam

    • umara

      Member
      October 27, 2023 at 6:42 am

      Thanks, it worked

  • Barış Bicer

    Moderator
    October 28, 2023 at 7:16 pm

    hi,

    As an addition to Midhun comment, never forget to refresh on paraview gui when you update or change something in openfoam side. To do this there are 2 ways:

    – you can upload dummy .foam file again into paraview

    – or you can refresh in left options of .foam file (also make on/off) in the paraview and then it will be seen.

    For your info.

    • umara

      Member
      October 30, 2023 at 9:08 am

      thanks

  • Barış Bicer

    Moderator
    November 1, 2023 at 7:32 pm

    You are welcome

Log in to reply.

error: Content is protected !!