Find answers, ask questions, and connect with our <br>community around the world.

Home Forums ANSYS Fluent Beginners to Advanced level Query regarding internal flow / globe valve (results)

  • Query regarding internal flow / globe valve (results)

    Posted by Aditya on October 7, 2023 at 5:26 pm

    Hi everyone,

    I just finished all the simulations for the internal flow case to determine the flow characteristics of a globe valve However, I am a bit skeptical regarding my results. I am not getting the trend line I hoped for. I was wondering if anyone got a similar result or could maybe give some suggestions regarding my data. I am attaching the results below. Any advice would be highly appreciated.

    Bibek replied 6 months, 1 week ago 2 Members · 2 Replies
  • 2 Replies
  • Aditya

    Member
    October 7, 2023 at 5:27 pm

    I am guessing the results, especially at 1mm were a bit off since the mesh was not good as the gap in lift is really small and we need to accommodate 5 boundary layers there.

  • Bibek

    Member
    October 13, 2023 at 1:14 pm

    Maybe you need to simulate it again. I’m getting around 1300N for delP = 5bar, lift = 1mm case.

Log in to reply.

error: Content is protected !!