Find answers, ask questions, and connect with our <br>community around the world.

Home Forums ANSYS Fluent Beginners to Advanced level Lesson 6 Mesh reinforcement and Body of Influence.

  • Rahul

    Member
    February 1, 2024 at 6:34 am

    Hi Thasiru,
    Please follow the sizing parameters mentioned in the lesson to first generate a coarse mesh. The maximum size in the screenshot you have shared seems to be very low, resulting in the mesh count going above the limit. The video was done considering the limitations of Ansys student editions. So you should be able to generate a mesh on your system.

    Once that is done, you can gradually refine the mesh if required by decreasing the minimum and maximum element size.

    Best regards
    Rahul
    Flowthermolab support

  • Thasiru

    Member
    February 1, 2024 at 4:24 pm

    I even did for the same parameters used in the video still it says the same sir. But I tried it for the mixing elbow with the same parameters used in the video for the mixer for that its working, but for the mixer its not.

    • Rahul

      Member
      February 1, 2024 at 6:05 pm

      Please take a screenshot of the sizing parameters you have used, based on the video, for the BOIs as well as for the surface mesh and any other refinements used and post it here so we can take a look.
      Since the parameters in the video gave a mesh below 500,000 cells, it should anyway be able to generate the mesh for your case.
      Regards
      Rahul

Log in to reply.

error: Content is protected !!