Find answers, ask questions, and connect with our <br>community around the world.

Home Forums ANSYS Fluent Beginners to Advanced level Floating point error in Centrifugal pump simulation

  • Floating point error in Centrifugal pump simulation

    Posted by Akshay on November 18, 2023 at 6:01 pm

    I am doing a centrifugal pump simulation in ANSYS FLUENT as described in the leacture-17, but as soon as try to run the calculation, I got reverse flow condition at the impeller inlet simultaneously the solution diverges, and the console shows floating point error with solution termination. I have also added an extra pipe at the inlet of the rotor to prevent reverse flow but still getting the same error.

    Akshay replied 5 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

error: Content is protected !!