Find answers, ask questions, and connect with our <br>community around the world.

Home Forums OpenFOAM Forum boundary layer mesh

  • boundary layer mesh

    Posted by Harshavardhan on December 6, 2022 at 12:30 pm

    Hi

    I copied the boundary layer mesh into constant folder. But when I open it in paraview I obtaine the castaled mesh rather than the boundary layer mesh.

     

    Barış Bicer replied 1 year, 4 months ago 2 Members · 5 Replies
  • 5 Replies
  • Barış Bicer

    Moderator
    December 6, 2022 at 8:33 pm

    Hi Konka,

    You dont need to do it. Just open paraview foam.foam and from time line switch from 1 to 3 and see the differences step by step.

    Actually why dont you show mesh here? It is not clear.

    Oh ok I just saw from your above picture that you are in time 1 (look at on the middle top –> Time 1) switch it to 3 and then you will see boundary layer as well.

     

  • Harshavardhan

    Member
    December 7, 2022 at 10:51 am

    Hi Baris,

    In the video it states that if the polymesh is copied to the constant folder, the time step 3 which is the boundary layer will be directly opened in the paraview. Also, I was not able to copy the motorbike set up from tutorials. I copied the file manually. If I try to copy it via the terminal I am gatting the followig error.

    Note: I am trying to run in another folder for the purpose for assignment.

     

     

  • Harshavardhan

    Member
    December 7, 2022 at 11:09 am

    Hi Baris,

    I fixed the second half of the question. It would be great if you could give your comments for the first half of the question.

  • Harshavardhan

    Member
    December 7, 2022 at 12:09 pm

    Hi Baris,

    Apologize I figured out how to solve it.

     

    thanks

  • Barış Bicer

    Moderator
    December 7, 2022 at 7:02 pm

    Good to know

Log in to reply.

error: Content is protected !!