Find answers, ask questions, and connect with our <br>community around the world.

Home Forums OpenFOAM Forum printstak error Reply To: printstak error

  • Srinivas

    Member
    February 15, 2023 at 5:18 am

    After the run of propeller case present in tutorial, I change the geometry of propeller with my propeller.

    I have mesh the geometry will. I have face one error (target face are not said) after google search I found that I have decompose the Mesh with scotch method. but It gives me the problem while reconstruct mesh. then I go with the hierarchical, it works.

    when I give the command “mpirun -np 4 pimpleFoam -parallel | tee log.propeller”

    above error came.

    then I delete the processor then run with only pimpleFoam, run stop automatically without showing any error.

error: Content is protected !!