Find answers, ask questions, and connect with our <br>community around the world.

Home Forums OpenFOAM Forum boundary layer mesh Reply To: boundary layer mesh

  • Barış Bicer

    Moderator
    December 6, 2022 at 8:33 pm

    Hi Konka,

    You dont need to do it. Just open paraview foam.foam and from time line switch from 1 to 3 and see the differences step by step.

    Actually why dont you show mesh here? It is not clear.

    Oh ok I just saw from your above picture that you are in time 1 (look at on the middle top –> Time 1) switch it to 3 and then you will see boundary layer as well.

     

error: Content is protected !!