FlowThermoLab
Validated in FTL FlowSuiteCompared with: Experiment · Ansys CFX

GT1544 centrifugal compressor

A centrifugal compressor is designed from scratch using a real compressor map (Garrett GT1544), aiming for lower losses, higher efficiency and wider operating range. Predicted performance and flow fields are benchmarked against the experimental map using two CFD solvers: FTL FlowSuite and Ansys CFX.

  • Radial compressor design
  • Turbocharger
  • MRF
  • Mixing plane
Static pressure and velocity: FlowSuite vs Ansys CFX
  • 1.98design pressure ratio
  • 170,000 rpmdesign speed
  • 0.5 Mcells, sector model
01 · Set-up

Model, mesh and settings

Baseline impeller design

Pressure ratio1.98
Corrected air flow9.2 lb/min
Rotational speed170,000 rpm
Exducer diameter43.9 mm
Inducer diameter32.85 mm
Number of vanes6
Tip clearance0.1 mm

Grid and solver settings

Inlet total pressure1 bar
Outlet mass flow rate0.05–0.08 kg/s
Inlet total temperature288.15 K
Rotor speed200,000 rpm
Meshabout 0.5 million cells, sector model
FluidAir (ideal gas)
Turbulence modelSST k-ω
Interface modelMixing plane (stage)
Impeller geometry
Computational domain with boundary conditions
Computational grid, about 0.5 million cells
02 · Results

What the comparison shows

Highlights

  • A centrifugal compressor was designed and validated using the compressor map of the Garrett GT1544 turbocharger.
  • The validated baseline model reproduces the measured aerodynamic behaviour, giving a reliable starting point for further design work.
Isentropic efficiency and total pressure ratio vs corrected flow: experiment (GT1544 map), FlowSuite and Ansys CFX